DUST-PROOF/WATER-PROOF TYPE INDUSTRIAL ROBOT SPECIFICATIONS MANUAL
5.3.2 Base Swivel Cover
The base swivel cover is secured to the base swivel unit by six Phillips truss head
screws (M4x8) with a packing inserted in between. When mounting the cover, be
careful that no cables get pinched in between.
Base swivel cover
Packing
* The internal cables are
omitted from the
illustration.
Fig. 5.2 Base swivel cover
!
CAUTION
• Be sure to always insert the packing. Also, be sure to apply Loctite to the
mounting bolts. Failure to apply Loctite will result in reduced
dust-proof/drip-proof performance and the ingress of water and dust.
• Packing that has been removed cannot be reused. Replace with new packing.
STE 85338
– 23 –
To Next Page
Loading...
