DUST-PROOF/WATER-PROOF TYPE INDUSTRIAL ROBOT SPECIFICATIONS MANUAL
STE 85338
– 26 –
Apply liquid gasket to the truss head
screw bearing faces (six screws)
Arm 2 cover (1)
Packing
5.3.4 Arm 2 Cover (1)
The arm 2 cover (1) is secured to arm 2 (1) by six Phillips truss head screws (M4x8)
with a rubber packing inserted in between.
Before mounting the cover, be sure to first apply liquid gasket to the bearing faces of
the six Phillips truss head screws (M4x8), and be careful that no cables get pinched in
between when mounting.
Fig. 5.5 Arm 2 cover (1)
!
CAUTION
• Be sure to always insert the packing. Be sure to apply liquid gasket to the
bearing faces of the mounting bolts. Failure to apply Loctite will result in
reduced dust-proof/drip-proof performance and the ingress of water and dust.
• Packing that has been removed cannot be reused. Replace with new packing.
* The internal cables are
omitted from the illustration.
To Next Page
Loading...
