DUST-PROOF/WATER-PROOF TYPE INDUSTRIAL ROBOT SPECIFICATIONS MANUAL
!
CAUTION
• The ingress of dust can occur if no air purge is applied.
• The controller is not protected against dust and water.
• Be sure to always use clean, dry air. If dry air is not used, condensation
occurs inside the robot, and the moisture accumulates, resulting in electrical
leakage or a malfunction.
• Do not apply a pressure exceeding the maximum specified pressure. This
can damage the seals and other components of the joints and reduce
dust-proof/water-proof performance.
STE 85338
– 18 –
To Next Page
Loading...
