31/68
5. Once the top of the rim is detached from the tyre, press the UP
button to bring the flange plate back up.
6. Remove the side ring with a hammer.
7. Remove the locking ring using a crowbar and hammer.
8. Remove both the detached side ring and the detached locking
ring.
9. Press the DOWN button again to remove the rim even further
from the tyre.
10. Loosen the advance band with the help of a crowbar.
11. Remove the advance band.
12. Remove the tyre from the cage.
13. Remove the cage from the solid tyre press.
14. Turn the cage over with two people, so that what was the top is
now the bottom.
15. Place the inverted cage back on the solid tyre press. The cage
will fit over the flange plate.
16. Put the wheel back onto the centre of the cage with the open
side up.
17. Place the cone on the tyre.
To Next Page
Loading...