Toyota 2GR-FE - Page 736

2GR-FE FUEL – FUEL PRESSURE PULSATION DAMPER
FU–23
FU
REMOVAL
1. DISCHARGE FUEL SYSTEM PRESSURE
HINT:
See page FU-1
2. DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
3. DRAIN ENGINE COOLANT (See page CO-5)
4. REMOVE FRONT WIPER ARM AND BLADE
ASSEMBLY LH (See page WW-9)
5. REMOVE FRONT WIPER ARM AND BLADE
ASSEMBLY RH (See page WW-9)
6. REMOVE FRONT FENDER TO COWL SIDE SEAL LH
(See page WW-9)
7. REMOVE FRONT FENDER TO COWL SIDE SEAL RH
(See page WW-9)
8. REMOVE COWL TOP VENTILATOR LOUVER SUB-
ASSEMBLY (See page WW-10)
9. REMOVE WINDSHIELD WIPER MOTOR AND LINK
ASSEMBLY (See page WW-10)
10. REMOVE COWL TOP PANEL OUTER SUB-
ASSEMBLY (See page ES-481)
11. REMOVE V-BANK COVER SUB-ASSEMBLY (See
page EM-23)
12. REMOVE AIR CLEANER CAP SUB-ASSEMBLY (See
page ES-503)
13. REMOVE INTAKE AIR SURGE TANK ASSEMBLY
(See page FU-13)
14. REMOVE FUEL PRESSURE PULSATION DAMPER
ASSEMBLY
(a) Remove the clip.
(b) Pull out the fuel pressure pulsation damper from the
fuel delivery pipe.
(c) Remove the O-ring from the fuel pressure pulsation
damper.
INSTALLATION
1. INSTALL FUEL PRESSURE PULSATION DAMPER
ASSEMBLY
(a) Apply a light coat of spindle oil or gasoline to a new
O-ring and install it to the fuel pressure pulsation
damper.
(b) Install the fuel pressure pulsation damper to the fuel
delivery pipe.
(c) Install the clip.
Clip
Pulsation Damper
O-Ring
A129609E01
Clip
Pulsation Damper
O-Ring
A129609E01