54
Chapter 6
Customize Your Network Settings
6. 2. 1. Configure the RADVD Address Type
1. Visit http://tplinkwifi.net or http://192.168.0.1, and log in with the password you set
for the router.
2. Go to Advanced > Network > LAN Settings.
3. Select IPv6 to configure IPv6 LAN parameters.
1 ) Select RADVD as the address type to make the router assign IPv6 address
prefixes to hosts.
Note:
Do not select the Enable RDNSS and Enable ULA Prefix check boxes unless required by your ISP. Otherwise
you may not be able to access the IPv6 network. For more information about RDNSS and ULA Prefix, contact
our technical support.
2 ) Keep Site Prefix Type as the default setting Delegated. If your ISP has provided
a specific IPv6 site prefix, select Static and enter the prefix.
3 ) Keep WAN Connection as the default settings.
4. Click Save to make the settings effective.
6. 2. 2. Configure the DHCPv6 Server Address Type
1. Visit http://tplinkwifi.net or http://192.168.0.1, and log in with the password you set
for the router.
2. Go to Advanced > Network > LAN Settings.
3. Select IPv6 to configure IPv6 LAN parameters.
To Next Page
Loading...
