TP-Link HC220-G1

9
Chapter 2 Connect the Hardware
• Method 3: Use the Sync button
Wireless devices that support WPS, including Android phones, tablets, most USB
network cards, can be connected to your Controller by this method.
Note:
• WPS is not supported by iOS devices.
• The WPS function cannot be configured if the wireless function of the Controller is disabled. Also, the WPS
function will be disabled if your wireless encryption is WEP. Please make sure the wireless function is enabled
and is configured with the appropriate encryption before configuring the WPS.
1 ) Tap the WPS icon on the device’s screen. Here we take an Android phone as an
example.
2 ) Immediately press the Sync button on your Controller.
3 ) The System Status LED flash for about two minutes during the WPS process.
WLAN
On
TP-Link
HomeNetwork
2ƱFH
TP-Link_123
TP-Link_ABC
MyHome
Test
Sync
Close to
2. 2. 2. Access Point Mode
In the access point mode, your Controller and Satellites extend the wireless coverage
of your network.
DevicesControllerWired Router
Ethernet4Ethernet3Ethernet1Ethernet2Internet
Ethernet2
WAN/LAN
LAN
Reset
ON/OFF
Power
WAN/LAN
LAN
WAN
1. Connect the power adapter to the Controller.