46
Chapter 8
Customize Your Network
Channel Width: Select the channel width from the drop-down list. The default setting is
Auto, which can adjust the channel width for your clients automatically.
Transmit Power: Select Low, Middle, or High to specify the data transmit power. The
default and recommended setting is
High.
8. 3. 2. Use WPS for Wireless Connection
You can use WPS (Wi-Fi Protected Setup) to add a new wireless device to your existing
network quickly and easily.
Method 1: Use the WPS button
Use this method if your client device has a WPS button.
1. Press the Sync button of the Controller.
2. Press the WPS button of the client device directly.
3. The Sync LED flashes for about 2 minutes during the WPS process.
4. When the Sync LED is on, the client device has successfully connected to the
Controller or the .
Method 2: Use the WPS button on the web management page
Use this method if your client device has a WPS button.
1. Visit
http://tplinkwifi.net, and log in with the password you set for the Controller.
2. Go to
Settings > Wireless > WPS.
3. Click Push Button.
4. Press the WPS button of the client device directly.
5. The Sync LED of the Controller flashes for about 2 minutes during the WPS process.
6. When the Sync LED is on, the client device has successfully connected to the
router.
Method 3: Enter the router’s PIN on your client device
Use this method if your client device asks for the router’s PIN.
1. Visit
http://tplinkwifi.net, and log in with the password you set for the Controller.
2. Go to
Settings > Wireless > WPS.
To Next Page
Loading...
