52
Chapter 8
Customize Your Network
8. 5. 2. Configure the DHCPv6 Server Address Type
1. Visit http://tplinkwifi.net, and log in with the password you set for the Controller.
2. Go to
Settings > Advanced Settings > DHCP Server.
3. Select IPv6 to configure IPv6 LAN parameters.
1 ) Select the DHCPv6 Server address type to make the Controller assign IPv6
addresses to hosts.
2 ) Specify the
Start/End IPv6 Address for the IPv6 suffixes. The Controller will
generate IPv6 addresses within the specified range.
3 ) Keep
Address Lease Time as default.
4 ) Keep
Site Prefix Type as the default value Delegated. If your ISP has provided a
specific IPv6 site prefix, select
Static and enter the prefix.
5 ) Keep
WAN Connection as the default setting.
4. Click Save to make the settings effective.
8. 6. Set Up a Dynamic DNS Service Account
Most ISPs (Internet service providers) assign a dynamic IP address to the router and
you can use this IP address to access your router remotely. However, the IP address
can change any time and you don’t know when it changes. In this case, you might need
the DDNS (Dynamic Domain Name Server) feature on the router to allow you and your
friends to access your router and local servers (FTP, HTTP, etc.) using domain name, in
no need of checking and remembering the IP address.
Note: DDNS does not work if the ISP assigns a private WAN IP address (such as 192.168.1.x) to the router.
To set up DDNS, please follow the instructions below:
To Next Page
Loading...
