TP-Link TD854W

Error! AutoText entry not defined. Error! AutoText entry not defined. User Guide
25
 New MAC Address: This field allows you to add a new MAC address to the Current Allowed
MAC Address Table. To add a new MAC address, enter the MAC address and then click
Add button.
 Current Allowed MAC Address Table: Displays the current allowed MAC address. Click the
Delete button and then the corresponding MAC address will be deleted.
After configuration, click Apply Changes button to save your changes.

Note:
After saving your configuration, you need to click the Save button on the left panel to make your
configuration take effect.
4.2.2.2 DHCP
Choose “Setup→LAN→DHCP” menu, and then you will see the DHCP Mode screen (shown in
Figure 4-7). Here you can configure the DHCP mode of your ADSL Router as None, DHCP Relay
or DHCP Server. DHCP stands for Dynamic Host Control Protocol. The DHCP Server gives out IP
addresses when a device is booting up and request an IP address to be logged on to the network.
Figure 4-8
 LAN IP Address: Displays the LAN IP address of the Modem Router
 Subnet Mask: Displays the subnet mask of the Modem Router.