TP-Link TD854W

Error! AutoText entry not defined. Error! AutoText entry not defined. User Guide
78
2) NTP
Figure 4-58
 State: Indicate the current state of NTP function. Choose to enable the NTP or not.
 Server/Server2: Enter the IP address or the host name of the NTP server.
 Interval: The interval time of NTP function.
 Time Zone: The time zone in which the device resides.
 Get GMT Time: After setting the NTP configuration correctly, click this button to start the NTP
function. Then you can see the GMT time obtained from NTP server.

Note:
If changes are made, after clicking Apply Changes button, a Save button will appear on the left
panel. You need to click the Save button to make your changes take effect.
4.6.5 Log
Choose “Maintenance→Log”, you can view and configure the logs of the Modem Router (shown
in Figure 4-59).