TP-Link TL-SG2216 - Show Bridge Port-Security; Show Bridge Address

37
Command Mode
Global Configuration Mode
Example
Add a filtering address entry whose VLAN ID is 1 and MAC address
00:1e:4b:04:01:5d:
TP-LINK(config)# bridge address filtering 00:1e:4b:04:01:5d 1
show bridge port-security
Description
The show bridge port-security command is used to configure the Port
Security for each port, such as configure the Max number of MAC addressed
that can be learned on the port and the Learn Mode.
Syntax
show bridge port-security [port-num]
Parameter
port-num —— The port number of the switch. By default, the Port Security
configuration of all ports is displayed.
Command Mode
Any Configuration Mode
Example
Display the Port Security configuration of port 2:
TP-LINK(config)# show bridge port-security 2
show bridge address
Description
The show bridge address command is used to display the information of all
Address entries.
Syntax
show bridge address { dynamic | static | filtering | all }
Parameter
dynamic | static | filtering | all —— the type of your desired entry
Command Mode
Any Configuration Mode