TP-Link TL-SG2216 - Preface

1
Preface
This Guide is intended for network administrator to provide referenced information about CLI
(Command Line Interface). The device mentioned in this Guide stands for TL-SG2216/TL-SG2424
Gigabit Smart Switch.
Overview of this Guide
Chapter 1: Using the CLI
Provide information about how to use the CLI, CLI Command Modes, Security Levels and some
Conventions.
Chapter 2: User Interface
Provide information about the commands used to switch between five CLI Command Modes.
Chapter 3: IEEE 802.1Q VLAN Commands
Provide information about the commands used for configuring IEEE 802.1Q VLAN.
Chapter 4: LAG Commands
Provide information about the commands used for configuring LAG (Link Aggregation Group).
Chapter 5:
User Manage Commands
Provide information about the commands used for user management.
Chapter 6: L
og Commands
Provide information about the commands used for configuring system log.
Chapter 7: Address Commands
Provide information about the commands used for Address configuration.
Chapter 8: System Commands
Provide information about the commands used for configuring the System information and System
IP, reboot and reset the switch, upgrade the switch system and other operations.
Chapter 9: Ethernet Configuration Commands
Provide information about the commands used for configuring the Bandwidth Control, Negotiation
Mode, and Storm Control for Ethernet ports.
Chapter 10: QoS Commands
Provide information about the commands used for configuring the QoS function.
Chapter 11: Port Mirror Commands
Provide information about the commands used for configuring the Port Mirror function.
Chapter 12: Port Isolation Commands
Provide information about the commands used for configuring the Port Isolation function.