66
show qos port-based
Description
The show qos port-based command is used to display the configuration of
QoS based on port priority.
Syntax
show qos port-based [interface-num]
Parameter
interface-num —— The Ethernet port selected to display the configuration. By
default, information of all the ports is displayed.
Command Mode
Any Configuration Mode
Example
Display the configuration of QoS for port 5:
TP-LINK# show qos port-based 5
show qos dot1p
Description
The show qos dot1p command is used to display the configuration of IEEE
802.1P Priority.
Syntax
show qos dot1p
Command Mode
Any Configuration Mode
Example
Display the configuration of IEEE 802.1P Priority:
TP-LINK# show qos dot1p
show qos dscp
Description
The show qos dscp command is used to display the configuration of DSCP
Priority.
To Next Page
Loading...
