84
Chapter 5
Congure the Router as an Access Point
• Rate - The unit for the Throughput.
• Run Time - How long the Throughput Monitor runs.
• Transmit - Wireless transmit rate information.
• Receive - Wireless receive rate information.
Click Start / Stop to start or stop wireless throughput monitor.
5. 5. DHCP
By default, the DHCP (Dynamic Host Configuration Protocol) Server is enabled and the
router acts as a DHCP server; it dynamically assigns TCP/IP parameters to client devices
from the IP Address Pool. You can change the settings of DHCP Server if necessary,
and you can reserve LAN IP addresses for specified client devices.
5. 5. 1. DHCP Settings
1. Visit http://tplinkwifi.net, and log in with the username and password you set for the
router.
2. Go to DHCP > DHCP Settings.
3. Specify DHCP server settings and click Save.
To Next Page
Loading...
