4
Chapter 1
Get to Know About Your Router
The router’s LEDs (view from left to right) are located on the front panel. You can check
the router’s working status by following the LED Explanation table.
LED Explanation
Name Status Indication
RE
Blinking
The router is connecting to the host wireless network. This may take
up to 2 minutes.
On
The router is working in Repeater mode and connected to the host
wireless network.
Wi-Fi
On The wireless function is enabled.
Off The wireless function is disabled.
PWR
On Power is on.
Blinking
The system is starting up or firmware is being upgraded. Do not
disconnect or power off the router.
Off Power is off.
WAN
Blue On The internet is available.
Orange On The router’s WAN port is connected, but the internet is not available.
Off The router’s WAN port is not connected to a powered-on device.
LAN
On At lease one LAN port is connected to a powered-on device.
Off No LAN port is connected to a powered-on device.
WPS
On/Off
This light remains on for 5 minutes when a WPS connection is
established, and then turns off.
Blinking WPS connection is in progress. This may take up to 2 minutes.