28
Chapter 4
Configure the Router in Wireless Router Mode
3. Enter other parameters if the ISP offers. The Default Gateway is automatically filled in
and is the same as the LAN IP address of the router.
4. Click SAVE .
Note:
To use the DHCP server function of the router, you must configure all computers on the LAN as Obtain an IP Address
automatically.
• To reserve an IP address for a specified client device:
1. Visit http://tplinkwifi.net, and log in with the password you set for the router.
2. Go to Advanced > Network > DHCP Server and locate the Address Reservation
section.
3. Click Add in the Address Reservation section.
4. Click VIEW CONNECTED DEVICES and select the you device you want to reserve an
IP for. Then the MAC and IP Address will be automatically filled in. You can also enter
the MAC and IP address of the client device.
• To check the DHCP client list:
1. Visit http://tplinkwifi.net, and log in with the password you set for the router.
2. Go to Advanced > Network > DHCP Server and locate the DHCP Client List section.
You can see the device information of the list.
3. Click Refresh to see the current attached devices.
To Next Page
Loading...
