26
Chapter 4
Configure the Router in Wireless Router Mode
1. Make sure the routers use different LAN IP addresses on the
same subnet. Disable Router B’s DHCP function.
2. Visit http://tplinkwifi.net, and log in with the password you
set for the router.
3. Go to Advanced > Network > Static Routing. Select your
current WAN Interface and click Save.
4. Click Add to add a new static routing entry. Finish the settings
according to the following explanations:
• Network Destination: The destination IP address that you
want to assign to a static route. This IP address cannot be
on the same subnet with the WAN IP or LAN IP of Router A. In
the example, the IP address of the company network is the
destination IP address, so here enter 172.30.30.1.
• Subnet Mask: Determines the destination network with the
destination IP address. If the destination is a single IP address,
enter 255.255.255.255; otherwise, enter the subnet mask of
How can I
do that?
To Next Page
Loading...
