44
Chapter 4
Configure the Router in Wireless Router Mode
Note:
If you want to disable this entry, click the Bulb icon .
4. 6. 3. Access Control
Access Control is used to block or allow specific client devices to access your network
(via wired or wireless) based on a list of blocked devices (Blacklist) or a list of allowed
devices (Whitelist).
Block or allow specific client devices to access my network (via
wired or wireless).
1. Visit http://tplinkwifi.net, and log in with the password you
set for the router.
2. Go to Advanced > Security > Access Control and enable
Access Control.
1. Select the access mode to either block (recommended) or
allow the device(s) in the list.
To block specific device(s)
1) Select Blacklist and click Save.
2) Select the device(s) to be blocked in the Online Devices
table.
I want to:
How can I
do that?
To Next Page
Loading...
