31
Chapter 4
Configure the Router in Wireless Router Mode
3. Follow one of the following methods to connect your client device to the router’s Wi-
Fi network.
Method ONE: Use the WPS Button
Use this method if your client device has a WPS button.
1. Press the WPS button of the modem router for 1 second.
2. Press the WPS button of the client device directly.
3. The WPS LED flashes for about 2 minutes during the WPS process.
4. When the WPS LED is on, the client device has successfully connected to the modem
router.
Method TWO: Use the WPS Button on the Web Management Page
Use this method if your client device has a WPS button.
1. Visit http://tplinkwifi.net, and log in with the password you set for the router.
2. Go to Wireless > WPS.
3. Click Start WPS on the page.
4. Press the WPS button of the client device directly.
5. The WPS LED of the router flashes for about 2 minutes during the WPS process.
6. When the WPS LED is on, the client device has successfully connected to the router.
Method Three: Enter the router’s PIN on your client device
Use this method if your client device asks for the router’s PIN.
1. Visit http://tplinkwifi.net, and log in with the password you set for the router.
2. Go to Advanced > Wireless > WPS page. Click Method Two--PIN.
To Next Page
Loading...
