42
Chapter 4
Configure the Router in Wireless Router Mode
3. Enable DoS Protection.
4. Set the level (Low, Middle or High) of protection for ICMP-FLOOD Attack Filtering,
UDP-FlOOD Attack Filtering and TCP-FLOOD Attack Filtering.
• ICMP-FLOOD Attack Filtering - Enable to prevent the ICMP (Internet Control
Message Protocol) flood attack.
• UDP-FlOOD Attack Filtering - Enable to prevent the UDP (User Datagram Protocol)
flood attack.
• TCP-FLOOD Attack Filtering - Enable to prevent the TCP (Transmission Control
Protocol) flood attack.
5. Click Save.
Tips:
1. The level of protection is based on the number of traffic packets. Specify the level at DoS Protection Level Settings.
2. The protection will be triggered immediately when the number of packets exceeds the preset threshold value, and the
vicious host will be displayed in the Blocked DoS Host List.
To Next Page
Loading...
