62
Chapter 4
Configure the Router in Wireless Router Mode
3. Keep the Port as the default setting. Enable Management over HTTPS and keep the
Port for HTTPS as the default setting. Enter the IP address or MAC address of the
local device to manage the router.
4. Click Save.
Now, you can manage the router over both HTTP (http://tplinkwifi.net) and HTTPS
(https://tplinkwifi.net).
Note: If you want that all local devices can manage the router, just leave the IP/MAC Address field blank.
4.10.6.3 Remote Management
By default, the remote devices are not allowed to manage the router from the internet.
You can enable remote management over HTTP and/or HTTPS if needed. HTTPS is a
more secure way to access the router.
Note:
If your ISP assigns a private WAN IP address (such as 192.168.x.x or 10.x.x.x), you cannot use the remote management
feature because private addresses are not routed on the internet.
Follow the steps below to allow remote devices to mange the router over HTTPS.
1. Visit http://tplinkwifi.net, and log in with the password you set for the router.
2. Go to Advanced > System Tools> Administration page. Locate the Remote
Management section.
To Next Page
Loading...
