Trace2O HT1000 - Page 27

HT1000_0.5 09/2015
27
from
to
Start:
print: F3
000001
000010
cancel: ESC
print all: F2
Mode
2
3
<Storage>
sorted: Code-No.
from _ _ _ _ _ _
Recall results of a selected Code No. range
Press [MODE], [Shift] + [3][2] keys.
Confirm with [ ] key.
The display shows:
Enter numeric code number (up to 6 places) for the first
required Code No., e.g.: [Shift] + [1].
Confirm with [ ] key.
to _ _ _ _ _ _
The display shows:
Enter numeric code number (up to 6 places) for the last re-
quired Code No., e.g.: [Shift] + [1][0].
Confirm with [ ] key.
The display shows:
• Press [ ] key and all stored results in the selected
Code No. range are displayed.
• Press [F3] key to print the displayed result.
• Press [F2] key to print all selected results.
• End with [ESC].
Note:
It is possible to cancel the entry by [ESC].
If you want to recall only results of one code number enter the same code number twice.
If you want to recall all results without code no. (code no. is 0) enter Zero [0] twice.