24WX
TrafiCam with TI (9 wires)
• Click Save As... from the File menu.
• Specify a file name and location.
• Click Save.
The configuration is saved as an XML file on to the PC.
Load a configuration to the TrafiCam sensor
• Click Open... from the File menu.
• Select the XML file.
• Click Open.
TrafiCam PC Tool displays the loaded configuration.
You modify the setup first or you activate this configuration for the TrafiCam sensor:
• Click Send Configuration from the File menu.
TrafiCam starts a learning cycle. The learning cycle takes a few minutes. During the learning cycle all zones are
active and the outputs change their status accordingly.
Upgrade firmware
• Click Upgrade Firmware from the Tools menu.
• Select the firmware file on the PC.
• Click Open.
The firmware upgrade process takes a few minutes. A pop-up window displays the status of the process.
• Click Close.
TrafiCam remains operational during the upgrade process.
To view product information, Select About... from the Tools menu. A pop-up window displays the product serial
number, the hardware revision, the firmware version and the lens type of the TrafiCam sensor.
Change the colour of the zones
The display colour of the zones in TrafiCam PC Tool is set by default. Proceed as follows if you wish to change these
colours:
• Select Advanced Settings from the Tools menu.
• Select Zone Colours...
• Click Set Colour to change the display colour of the zones.
• Click OK.
To Next Page
Loading...