Need help?Do you have a question about the Traficon TrafiCam and is the answer not in the manual?
General| Brand | Traficon |
|---|---|
| Model | TrafiCam |
| Category | Digital Camera |
| Language | English |
Describes compliance with EN55022 and FCC Part 15 regulations for radio interference.
Covers copyright notice, company liability, and information change policy.
Overview of the TrafiCam system and its capabilities.
Guide on how to use the user manual and other resources.
Lists and illustrates the physical components of the TrafiCam system.
Diagram showing the system architecture and connections.
Details front/side views and opened sensor components.
Pinout details for sensor connectors CN1/CN2 and TrafiCam LED status codes.
Describes the TI interface module and its connectors J1 and J4.
Details the pin assignments for interface connectors J1 and J4.
Overview of cables used for sensor, interface, and PC connections.
Describes brackets and tube for sensor mounting.
Instructions for mounting the TrafiCam sensor onto a pole.
Detailed steps for connecting the TrafiCam sensor cable to the interface.
Procedure for mounting the TI interface onto a DIN rail.
Steps to connect the interface to the traffic controller and PC.
Guidelines for periodic cleaning and system checks.
Steps to install the TrafiCam PC Tool software.
Instructions for setting up the correct COM port for PC communication.
Description of the TrafiCam PC Tool graphical interface elements.
Explains fundamental operations within the PC Tool.
Guide to defining and editing detection zones within the sensor.
Explains how zones are displayed and defined by points.
Configuring zones for stationary vehicle detection (stop mode).
Defines logical relations (OR/AND) for output signals.
Adjusting output behavior for assigned and unassigned outputs.
Process for sending and activating sensor configurations.
Recommendations for optimal zone dimensions and placement.
Techniques for overlapping zones and detection considerations at night.
How to configure zones for specific traffic directions.
Settings for detection and quality recall failsafe modes.
Parameters for detection recall activation delay.
Parameters for quality recall threshold and timeout.
Details on suppression of unwanted detections (inverse direction, shadows, etc.).
Configuration of Presence Time Off parameter.
Options to enable or disable the sensor's detection LED.
How to view live detection on the video image.
Setting timing parameters for zone detection outputs.
Configuration for using TrafiCam as a vehicle counter.
Setup for generating pulse outputs upon detection.
Diagrams and parameters for pulse generation.
Procedures for backing up and restoring sensor configurations.
Steps to save the sensor setup to a file on the PC.
Steps to load a saved configuration onto the TrafiCam sensor.
Instructions for updating the sensor's firmware.
Customizing the colours of detection zones in the PC Tool.
Technical details of the TrafiCam camera sensor.
Physical dimensions and materials used for the sensor.
Details on communication ports and output capabilities.
Input power requirements and operating environmental conditions.
Information on regulatory standards met by the device.
Physical dimensions and communication interface of the TI module.
Details on power supply and output specifications for the TI module.
Regulatory information specific to the TI interface.
Guidance on choosing lenses and positioning the sensor.
Table detailing focal distance, field of view, and detection area for lenses.
Advice on optimal height, position, and orientation for the sensor.
Table showing detection distances based on camera height for wide angle lens.
Table showing detection distances based on camera height for narrow angle lens.
Schematic illustrating the wiring for TrafiCam outputs.
Table mapping wire colours to their function for different cable types.
To Next Page