EasyManuals Logo
Home>Trane>Air Conditioner>IntelliPak

Trane IntelliPak User Manual

Trane IntelliPak
192 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
10 RT-SVX36K-EN
Model Number Descriptions
DIGIT 18 - ZONE SENSOR
0 = None
A = Dual Setpoint Manual or Auto
Changeover (BAYSENS108*)
B = Dual Setpoint Manual or Auto
Changeover w/ System Function
Lights (BAYSENS110*)
C = Room Sensor w/ Override and
Cancel Buttons (BAYSENS073*)
D = Room Sensor w/Temperature
Adjustment and Override and
Cancel Buttons (BAYSENS074*)
L = Programmable Zone Sensor w/
System Function Lights for both
CV and VAV (BAYSENS119*)
Note: *Asterisk indicates current model
number digit A, B, C, etc. These
sensors can be ordered to ship
with the unit.
DIGIT 19 - AMBIENT CONTROL
0 = Standard
DIGIT 20 - AGENCY APPROVAL
0 = None (cULus Gas Heater, see note)
1 = cULus
Note: Includes cULus classified gas
heating section only when second
digit of Model No. is a "F."
DIGITS 21 - 38 -
MISCELLANEOUS
21 A = Unit Disconnect Switch
22 B = Hot Gas Bypass
23 C = Economizer Control w/
Comparative Enthalpy
23 Z = Economizer Control w/
Reference Enthalpy
23 W = Economizer Control w/Dry Bulb
24 E = Low Leak Outside Air Dampers
25 F = High DuctTemperature
Thermostat
26 G = High Capacity Evap. Coil
(105Ton)
H = High Cap. Evap. Coil and High
Eff. Cond. Coil (90 Ton)
27 0 = Air-Cooled Aluminum
Condenser Coil
J = Corrosion-Protected
Condenser Coil
28 K = Generic B.A.S Module
R = Rapid Restart
29 A = Motors w/ Internal Shaft
Grounding
30 M = Remote Human Interface
31 N = Ventilation Override Module
32 0 = None
R = Extended Grease Lines
1 = Differential Pressure Gauge
2=
Extended Grease Lines and
Differential Pressure Gauge
33 0 = Standard Panels
T = Access Doors
U = IRU - w/ Std Panels
W = IRU - w/ Access Doors
Y = IRU w/SST - w/ Std Panels
34 V = Inter-Processor
Communication Bridge
35 Y = Trane Communication Interface
(TCI) Module
M = BACnet Communication
Interface (BCI) Module
7 = Trane LonTalk Communication
Interface (LCI) Module
37 6 = Factory-Powered 15A GFI
Convenience Outlet
Tip: EXAMPLE
Model numbers:
SXHK*1140AH8CECD8001**Z
describes a unit with the following
characteristics:
DX cooling with extended casing,
no heat, 105 ton nominal cooling
capacity, 460/60/3 power supply,
100 percent exhaust with Statitrac,
30 h.p. exhaust fan motor with
drive selection No. 8 - (800 RPM),
high-efficiency throwaway filters,
50 hp supply fan motor with 1200
RPM, economizer, w/ reference
enthalpy control, Supply and
Exhaust with VFD but no bypass,
cULus agency approval.
The service digit for each model
number contains 36 digits; all 36
digits must be referenced.

Table of Contents

Other manuals for Trane IntelliPak

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Trane IntelliPak and is the answer not in the manual?

Trane IntelliPak Specifications

General IconGeneral
BrandTrane
ModelIntelliPak
CategoryAir Conditioner
LanguageEnglish

Related product manuals