[38] Digital input DI33 Use the value of DI33 in the logic rule (High = TRUE).
[39] Start command This logic rule is TRUE if the adjustable frequency drive is started by any
means (either via digital input, serial communication bus or other).
[40] Drive stopped This logic rule is TRUE if the adjustable frequency drive is stopped or
coasted by any means (either via digital input, serial communication bus
or other).
[41] Reset Trip This logic rule is TRUE if the adjustable frequency drive is tripped (but
not trip-locked) and the reset button is pressed.
[42] Auto Reset Trip This logic rule is TRUE if the adjustable frequency drive is tripped (but
not trip-locked) and an automatic reset is issued.
[43] OK Key This logic rule is TRUE if the OK key on the keypad is pressed.
[44] Reset Key This logic rule is TRUE if the Reset key on the keypad is pressed.
[45] Left Key This logic rule is TRUE if the Left key on the keypad is pressed.
[46] Right Key This logic rule is TRUE if the Right key on the keypad is pressed.
[47] Up Key This logic rule is TRUE if the Up key on the keypad is pressed.
[48] Down Key This logic rule is TRUE if the Down key on the keypad is pressed.
[50] Comparator 4 Use the result of comparator 4 in the logic rule.
[51] Comparator 5 Use the result of comparator 5 in the logic rule.
[60] Logic rule 4 Use the result of logic rule 4 in the logic rule.
[61] Logic rule 5 Use the result of logic rule 5 in the logic rule.
[70] SL Timeout 3 Use the result of timer 3 in the logic rule.
[71] SL Timeout 4 Use the result of timer 4 in the logic rule.
[72] SL Timeout 5 Use the result of timer 5 in the logic rule.
[73] SL Timeout 6 Use the result of timer 6 in the logic rule.
[74] SL Timeout 7 Use the result of timer 7 in the logic rule.
[80] No Flow
[81] Dry Pump
[82] End of Curve
[83] Broken Belt
4-112 TR200 Programming Guide
To Next Page
Loading...
