Trane TR200 - Page 181

16-52 Feedback [Unit]
Range: Function:
0.000
Proc-
essCtrlU-
nit*
[-999999.999 - 999999.999
ProcessCtrlUnit]
View value of resulting feedback value after processing of Feedback 1-3
(see par.16-54
Feedback 1 [Unit], par.16-55 Feedback 2 [Unit] and par.
16-56) in the feedback manager.
See par. 20-0*
Feedback .
The value is limited by settings in par. 20-13 and par. 20-14. Units as set
in par.20-12
Reference/Feedback Unit.
16-53 Digi Pot Reference
Range: Function:
0.00 N/
A*
[-200.00 - 200.00 N/A] View the contribution of the digital potentiometer to the actual reference.
16-54 Feedback 1 [Unit]
Range: Function:
0.000
Proc-
essCtrlU-
nit*
[-999999.999 - 999999.999
ProcessCtrlUnit]
View value of Feedback 1, see par. 20-0*
Feedback .
The value is limited by settings in par.20-13
Minimum Reference/
Feedb. and par.20-14 Maximum Reference/Feedb.. Units as set in par.
20-12
Reference/Feedback Unit.
16-55 Feedback 2 [Unit]
Range: Function:
0.000
Proc-
essCtrlU-
nit*
[-999999.999 - 999999.999
ProcessCtrlUnit]
View value of Feedback 2, see par. 20-0*
Feedback .
The value is limited by settings in par. 20-13 and par. 20-14. Units as set
in par.20-12
Reference/Feedback Unit.
16-56 Feedback 3 [Unit]
Range: Function:
0.000
Proc-
essCtrlU-
nit*
[-999999.999 - 999999.999
ProcessCtrlUnit]
View value of Feedback 3, see parameter group 20-0*
Feedback .
The value is limited by settings in par.20-13
Minimum Reference/
Feedb. and par.20-14 Maximum Reference/Feedb.. Units as set in par.
20-12
Reference/Feedback Unit.
16-58 PID Output [%]
Range: Function:
0.0 %* [0.0 - 100.0 %]
16-6* Inputs and Outputs
Parameters for reporting the digital and analog IO ports.
16-60 Digital Input
Range: Function:
0 N/A* [0 - 1023 N/A] View the signal states from the active digital inputs. Example: Input 18
corresponds to bit no. 5, ‘0’ = no signal, ‘1’ = connected signal. Bit 6 works
in the opposite way, on = '0', off = '1' (safe stop input).
Parameter Description
4-144 TR200 Programming Guide