Trane TR200 - Electrical Installation; Fuse Selection for Drives with Internal Drive Fusing

Status display II:
See the operating variables (1.1, 1.2, 1.3, and 2)
shown in the display in this illustration.
In the example, Speed, Motor current, Motor power
and Frequency are selected as variables in the first
and second lines.
1.1, 1.2 and 1.3 are shown in small size. 2 is shown in
large size.
1.1
1.3
1. 2
2
Status display III:
This state displays the event and action of the Smart
Logic Control. For further information, see section
Smart Logic Control .
1
3
0
B
P
0
6
3
.
1
0
Display Contrast Adjustment
Press [status] and [
Ⴃ
] for darker display
Press [status] and [
Ⴍ
] for brighter display
T
op section
Middle section
Bottom section
LEDs:
If certain threshold values are exceeded, the alarm and/or warning LED lights up. A status and alarm text appear
on the control panel.
The On LED is activated when the adjustable frequency drive receives power from AC line voltage, a DC bus
terminal, or an external 24 V supply. At the same time, the back light is on.
H
How to Program
TR200 Programming Guide 3-3