Select [Changes Made] to get information about:
• The last 10 changes. Use the up/down navigation keys to scroll between the last 10 changed parameters.
• The changes made since default setting.
to get information about the display line readouts. The information is shown as graphs.
Only display parameters selected in par.0-20
Display Line 1.1 Small and par.0-24 Display Line 3 Large can be
viewed. It is possible to store up to 120 samples in the memory for later reference.
Quick Setup
Efficient Parameter Set-up for TR200 Applications:
The parameters can easily be set up for the vast majority of the TR200 applications only by using the [Quick
Set-up] option.
After pressing [Quick Menu], the different choices in the quick menu are listed. See also figure 6.1 below and
tables Q3-1 to Q3-4 in the following Function Set-ups section.
Example of using the Quick Set-up option:
Assume you want to set the ramp-down time to 100 seconds!
1. Select [Quick Setup]. The first par.0-01
Language in Quick Set-up appears
2.
Press [
Ⴍ
] repeatedly until par.3-42 Ramp 1 Ramp-down Time appears with the default setting of 20 seconds
3. Press [OK]
4.
Use the [
Ⴑ
] button to highlight the third digit before the comma
5.
Change '0' to '1' by using the [
Ⴃ
] button
6.
Use the [
Ⴇ
] button to highlight the digit '2'
7.
Change '2' to '0' with the [
Ⴍ
] button
8. Press [OK]
The new ramp-down time is now set to 100 seconds.
It is recommended to do the set-up in the order listed.
NOTE: A complete description of the function is found in the parameter sections of this manual.
Figure 3. 6: Quick Menu view.
The Quick Set-up menu gives access to the 18 most important set-up parameters of the adjustable frequency
drive. After programming, the adjustable frequency drive will, in most cases, be ready for operation. The 18
Quick Set-up parameters are shown in the table below. A complete description of the function is given in the
parameter description sections of this manual.
TR200 Programming Guide 3-9
To Next Page
Loading...
