Trane TR200 - Page 293

Ramp 2 Ramp-up Time 3-51 4-43
Ramp 2 S-ramp Ratio At Accel. End 3-56
4-43
Ramp 2 S-ramp Ratio At Accel. Start 3-55
4-43
Ramp 2 S-ramp Ratio At Decel. End 3-58
4-44
Ramp 2 S-ramp Ratio At Decel. Start 3-57
4-43
Ramp Delay 3-95
4-45
Ramp Time 3-91
4-45
Rated Motor Speed
2-3
Rcd
2-6
Readout And Programming Of Indexed Parameters
3-17
Readout: Linked Set-ups 0-13
4-7
Readout: Prog. Set-ups / Channel 0-14
4-7
Reference % 16-02
4-140
Reference 1 Source 3-15
4-39
Reference 2 Source 3-16
4-40
Reference 3 Source 3-17
4-41
Reference Function 3-04
4-38
Reference Site 3-13
4-39
[Reference Unit] 16-01
4-140
Refrigerant 20-30
4-163
Regional Settings 0-03
4-3
[Relay Output Bin] 16-71
4-147
Relay Outputs
4-66
Reset Continuous Bin Data 23-66
4-206
Reset Control Timeout 8-06
4-94
Reset Energy Log 23-54
4-202
Reset Kwh Counter 15-06
4-131
Reset Maintenance Word 23-15
4-199
Reset Mode 14-20
4-123
Reset Running Hours Counter 15-07
4-131
Reset Slc 13-03
4-108
Reset Timed Bin Data 23-67
4-206
[Reset] Key On Lcp 0-43
4-17
Resonance Dampening 1-64
4-29
Resonance Dampening Time Constant 1-65
4-29
Reverse Select 8-54
4-98
Rfi 1 14-50
4-128
Running Hours 15-01
4-131
S
Safety Note 1-1
Safety Precautions
2-7
Safety Regulations
1-2
Samples Before Trigger 15-14
4-134
Semi-auto Bypass Set-up 4-64
4-51
Serial Communication
2-4
Service Code 14-29
4-126
Setpoint 1 20-21
4-162
Setpoint 2 20-22
4-162
Setpoint 3 20-23
4-162
Setpoint Boost 22-45
4-190
Set-up Copy 0-51
4-19
Set-up Select 8-55
4-98
Short Cycle Protection
4-191
Sl Controller Action 13-52
4-118
Sl Controller Event 13-51
4-117
Sl Controller Mode 13-00
4-104
Sl Controller State 16-38
4-143
Sl Controller Timer 13-20
4-110
Index
7-10 TR200 Programming Guide