Trane TR200 - Page 5

2.7.3 Anti-condensation Heater 30
2.7.4 Brake Chopper 30
2.7.5 Mains Shield 30
2.7.6 Mains Disconnect 30
2.7.7 Contactor 30
2.7.8 Circuit Breaker 31
3 Start Up and Commissioning
32
3.1 Pre-start
32
3.2 Applying Power
33
3.3 Basic Operational Programming
33
3.4 Local-control Test
34
3.5 System Start Up
35
4 User Interface
36
4.1 Local Control Panel
36
4.1.1 LCP Layout 36
4.1.2 Setting LCP Display Values 37
4.1.3 Display Menu Keys 37
4.1.4 Navigation Keys 38
4.1.5 Operation Keys 38
4.2 Back Up and Copying Parameter Settings
38
4.2.1 Uploading Data to the LCP 39
4.2.2 Downloading Data from the LCP 39
4.3 Restoring Default Settings
39
4.3.1 Recommended Initialisation 39
4.3.2 Manual Initialisation 39
5 Programming
40
5.1 Introduction
40
5.2 Programming Example
40
5.3 Control Terminal Programming Examples
42
5.4 International/North American Default Parameter Settings
42
5.5 Parameter Menu Structure
43
5.6 Remote Programming with Trane Drive Utility (TDU)
48
6 Application Examples
49
6.1 Introduction
49
6.2 Application Examples
49
7 Status Messages
54
7.1 Status Display
54
Contents TR200 D-Frame Operating Instructions
2
BAS-SVX54B-EN