To Next Page

To Previous Page

VAV-SVX07B-EN 37

Tracer™ UC400 Controller Operations

Controller Settings Utility

Use the Controller Settings button to perform the following:

• View analog, binary, and multistate points and I/O references

• Configure new points and edit the configuration of existing points

• Set the Tracer UC400 controller date and time, including format and time zone

• Set the Tracer UC400 controller units (SI or IP)

• Set the baud rate and view the device rotary dial settings

• Soft-set the BACnet Device ID

• Add expansion modules

• Clear controller and event receivers

Analog, Binary, and Multistate Tabs

Use the Analog, Binary, and Multistate tabs to view, create, edit, or delete the currently configured

input, output, and value objects residing on the equipment controller. In addition, point

configurations can be edited from the respective status pages with TU 8.1 or higher.

Note: To create new points to utilize the spare inputs/outputs and/or software-only points, refer

to the Tracer UC400 Programmable Controller Installation, Operation, and Maintenance

Manual (BAS-SVX20).

The following field descriptions apply to the Inputs, Outputs, and Values grid column areas of the

screen.

Actions (Drop-down Menu)

• Copy: Use this option to copy an existing point configuration under a different name and then

modify it to avoid extra typing.

• Edit: Use this option to edit an existing point configuration. The appropriate Properties dialog

box displays.

• Delete: Use this option to delete one or more point configurations.

• Add New button: Click this button to configure a new point. The appropriate Properties dialog

box displays.

Grid Columns

• Instance: Displays the sequence instance assigned to the point.

• Name: Displays the name of the point.

• Reference: Identifies the source or target of information supplied to or from the point.

• State: Displays the current state of the point. (Point states are Normal, Out of Service, Fault,

and Alarm.)

• Locked: Indicates if the point is locked (not modifiable).

• Save to File: Saves the points listed on this screen to a new or existing file on the hard drive.

• Send to Device: Saves the points to the controller.

• Cancel: Returns the screen to its condition at the last save.

Trane Tracer User Manual

Questions and Answers: