Transmille 8071 - Calibration

8000 SERIES OPERATION MANUAL TRANSMILLE LTD.
TRANSMILLE LTD. PAGE 55
Calibration
Command Format Parameters
Enter Password k<Password> Password = 1 to 10
digits
Set Password K<Password> Requires calibration
mode to be active
If a command includes a value which cannot be set due to, for example, the value being higher than
the range maximum, the multimeter will reject the command and stay set as it is (the multimeter will
return a *9 code).
The multimeter will respond to the commands sent with the response codes as detailed at the
beginning of this section. These codes can be used to ensure that potentially hazardous conditions
are clearly indicated to the operator and to maintain control of these outputs. This allows the
multimeter to be returned to a safe state once the testing required has been completed.
This functionality is employed within the ProCal calibration software from Transmille to allow safe
operation of the multimeter.