8000 SERIES OPERATION MANUAL TRANSMILLE LTD.
TRANSMILLE LTD. PAGE 52
Programming Commands Overview
The 8000 series is controlled by a set of simple high level commands which can be used either
individually or as part of a command sequence to setup the 8000 Series multimeter to required state.
The commands can be joined together using the / (forward slash) character.
The required terminator for the commands to be detected by the multimeter is a carriage return
(ASCII character 13) and should be the last character sent on a command line
For Example :
Command1/Command2 <CR>
Where each command is represented as Commandx
(x being the command number)
and the carriage return (ASCII character 13) is represented by <CR>
To Next Page
Loading...