8000 SERIES OPERATION MANUAL TRANSMILLE LTD.
TRANSMILLE LTD. PAGE 15
Powering up the multimeter
After connecting line power, the multimeter can be switched on with the line power switch above the
mains inlet socket on the rear panel.
The front panel displays will illuminate and indicate if the instrument is in evaluation mode for a
period of 5 seconds, giving the user a chance to unlock the instrument. The start-up sequence will
operate internal circuits indicating initial power up during which time the processor performs a self
test of the instrument - the display will then switch to measurement display mode.
Transmille Ltd.
Æ
Evaluation 60 days
Æ
0.0000mV D.C.
Allow the multimeter to warm up for 3 hours to obtain 90% of full specifications.
To Next Page
Loading...