Transmille 8071 - 8000 Series DMM Remote Commands; Scpi; General

8000 SERIES OPERATION MANUAL TRANSMILLE LTD.
TRANSMILLE LTD. PAGE 54
8000 Series DMM Remote Commands
All commands followed by Carriage Return (ASCII 13)
SCPI
Command Format Parameters
Transmit Reading READ?
*TRG
Select AC Voltage Range RANGE:AC:VOLTAGE <value>
RANGE:AC:VOLT <value>
value = 0.01 to 1000
Select DC Voltage Range RANGE:DC:VOLTAGE <value>
RANGE:DC:VOLT <value>
value = 0.1 to 1000
Select AC Current Range RANGE:AC:CURRENT <value>
RANGE:AC:CURR <value>
value = 10
-4
to 30
Select DC Current Range RANGE:DC:CURRENT <value>
RANGE:DC:CURR <value>
value = 10
-8
to 30
Select 4-Wire Resistance RANGE:FRES <value>
RANGE:FRESISTANCE <value>
value=1 to 10
7
Select 2-Wire Resistance RANGE:RES <value>
RANGE:RESISTANCE <value>
value=1 to 10
12
(value may be modified
by SI Prefixes: n, u, m,
k, M, G, T)
General
Command Format Parameters
Use Rear Terminals r
Use Front Terminals f
Set Filter Range F<Filter Range> Filter Range = 1 to 9 for
filter times 250ms – 64s
Set Digits D<Digits> Digits = 4 to 8
Show Status s
Set Null n
Clear Null N
Display Date a
Version Information v
Internal Temperature TEMP?
Example Commands (where <CR> denotes Carriage Return (ASCII 13) :
Required
Output
Range
Command
Output
Value
Command
Separator
Filter
Command
Terminator
(Carriage
Return)
1V DC @ 2s Filter RANGE:DC:VOLT 1 / F4 <CR>
10V AC @ 4s Filter RANGE:AC:VOLT 10 / F5 <CR>
100mA DC @
500ms Filter
RANGE:DC:CUR
R
0.1 / F2 <CR>