Need help?Do you have a question about the TRIATEK FMS-2000M and is the answer not in the manual?
How to view network variable readings on the home screen.
Steps to select which network variables are displayed on the home screen.
Step-by-step guide to configure language, units, orientation, and isolation mode.
Settings affecting the entire monitor, like units, language, orientation, and Safety Halo.
Managing user access levels, creating admin and restricted user accounts, and passwords.
Configuring BACnet MS/TP network settings like device ID, MaxMaster, baud rate, and MAC address.
Setting up parameters for individual rooms, including naming, isolation mode, and door switch.
Details on integrating the monitor with Building Management Systems via analog and binary inputs.
Performing zero calibration, setting alarm limits for pressure sensors.
Accessing and configuring alarm settings for each pressure sensor.
Accessing monitor information and performing a soft reboot.
Controls display response to differential pressure alarms (audible, mute, night).
Sets a delay before audible alarms sound when a door opens.
Temporarily mutes the audible alarm for a specified duration.
Enabling and adjusting the brightness, auto-dim, and dimmed period for the 360° Safety Halo.
Configures the monitor for reduced audible alarm during night hours.
Quickly access and adjust the 360° Safety Halo brightness.
Quickly select alarm modes like Audible, Mute, or Night.
Quickly change the isolation mode setting for the room.
How to view network variable readings on the home screen.
Steps to select which network variables are displayed on the home screen.
Step-by-step guide to configure language, units, orientation, and isolation mode.
Settings affecting the entire monitor, like units, language, orientation, and Safety Halo.
Managing user access levels, creating admin and restricted user accounts, and passwords.
Configuring BACnet MS/TP network settings like device ID, MaxMaster, baud rate, and MAC address.
Setting up parameters for individual rooms, including naming, isolation mode, and door switch.
Details on integrating the monitor with Building Management Systems via analog and binary inputs.
Performing zero calibration, setting alarm limits for pressure sensors.
Accessing and configuring alarm settings for each pressure sensor.
Accessing monitor information and performing a soft reboot.
Controls display response to differential pressure alarms (audible, mute, night).
Sets a delay before audible alarms sound when a door opens.
Temporarily mutes the audible alarm for a specified duration.
Enabling and adjusting the brightness, auto-dim, and dimmed period for the 360° Safety Halo.
Configures the monitor for reduced audible alarm during night hours.
Quickly access and adjust the 360° Safety Halo brightness.
Quickly select alarm modes like Audible, Mute, or Night.
Quickly change the isolation mode setting for the room.
To Next Page
General