TRIATEK FMS-2000M - System Overview

TRIATEK FMS-2000M

27 pages

Save Page as PDF

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

FMS-2000M

LIT-12013580

12

Figure 10: FMS-2000M system diagram

Item Component

1 FMS-2000M monitor

2 Remote pressure sensor

3 BMS

4 Temperature sensor

5 Humidity sensor

6 Air flow sensor

7 Air changes

8 CO

System overview

Table 3: FMS-2000M system diagram

Table of Contents

Table of Contents6
Introduction8
Display Overview8
- Multi-Room Monitoring Overview10
Navigating the Multi-Room Monitor Home Screen11
- Viewing All Network Variables11
- Changing the Network Variable that Displays on the Home Screen11
System Overview12
Initial Setup13
- Completing the Initial Setup13
Configuration14
- Global Settings14
- Choosing a Unit of Measure14
- Choosing a Language14
- Choosing the Device Orientation14
- Turning on the 360° Safety Halo™ and Adjusting the Brightness of the 360° Safety Halo14
- Adjusting the 360° Safety Halo, Nightly Auto-DIM, and Dimmed Period14
- Adjusting the Screen Brightness14
User Accounts15
- Admin User Capabilities15
- Restricted User Capabilities15
- User Name and Password Requirements15
- Creating the Admin User Account and Password15
- Deleting Users16
- Changing a User Name16
- Changing the Access Level of a Restricted User to an Admin User16
- Changing the Access Level of an Admin User to a Restricted User16
- Updating the PIN of a Restricted User16
- Forgetting Your Password or PIN16
Network Setup17
- Bacnet MS/TP Network Setup17
- Setting up the Device ID Offset17
- Setting up the Maxmaster17
- Choosing the Baud Rate17
- Setting the MAC Address for Bacnet MS/TP17
Room Setup18
- Naming the Device or Parameter18
- Changing the Isolation Mode18
- Configuring the Door Switch18
- Setting up a Delay18
- Network Variables18
BMS Integration19
Sensors21
- Zero Calibration21
- Creating a Zero Offset21
- Resetting the Zero Offset21
- Setting up Alarms for each Pressure Sensor21
Alarms22
- Setting up Alarms for each Pressure Sensor22
Diagnostics22
- Viewing the about this FMS Information22
- Rebooting the Monitor22
Restricted User Access22
- Changing the Time and Date22
- Adjusting the Alarm Mode23
- Setting the Audible Alarm Delay23
- Changing the Audible Alarm Snooze23
- Switching on and Adjusting the Brightness of the 360° Safety Halo23
- Adjusting the 360° Safety Halo Nightly Auto-DIM and Dimmed Period23
- Setting the Night Mode23
- Adjusting Screen Brightness24
- Changing the Isolation Mode24
Quick Links24
- Adjusting the 360° Safety Halo and Brightness24
- Adjusting the Alarm Mode Quick Links24
- Adjusting the Isolation Mode Quick Link24
Upgrading an FMS-1655M Monitor to an FMS-2000M Monitor25
Technical Specifications26
Cleaning the Display27
North American Emissions Compliance27

Other manuals for TRIATEK FMS-2000M

Installation Guide31 pages