EasyManua.ls Logo

Trilogy Communications Commander User Manual

Default Icon
81 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
INSTALLATION GUIDE
ISSUE 9.1
TRILOGY COMMUNICATIONS LIMITED
26 Focus Way
Andover
Hampshire
SP10 5NY
United Kingdom
Telephone. +44 (0) 1264 384000
Fax. +44 (0) 1264 334806
www.trilogycomms.com
DIGITAL INTERCOM

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the Trilogy Communications Commander and is the answer not in the manual?

Trilogy Communications Commander Specifications

General IconGeneral
BrandTrilogy Communications
ModelCommander
CategoryIntercom System
LanguageEnglish

Summary

Installation

Introduction to Installation

Outlines the steps for installing the Commander matrix system.

Rack Mounting Guidelines

Information on matrix dimensions, panel sizes, and rack mounting considerations.

System Assembly Process

Details on fitting modules into the frame in the correct sequence for system assembly.

500-08 Series Changeover Card

Instructions for fitting the 500-08 Changeover Card and its links.

500-02 Series Talkback Controller Card

Information on installing the 500-02 Talkback Controller card, including versions and settings.

500-01 Series TDM Controller Card

Details on fitting the 500-01 TDM Controller card and its major components.

500-06 Series Matrix Cards

Instructions for fitting 500-06 Matrix Cards and compatibility link settings.

Mains Connection and Fusing

Details on connecting the power supply and its fusing requirements.

Earthing Requirements

Specifications for the earthing requirements of the system.

Starting the System

Guidance on powering up the system and initial boot operations.

Connecting to the Matrix

Connecting the Matrix Ports

Shows the rear view of the rack with connector details and port numbering.

Connecting the PC to the Commander System

Outlines options for connecting a PC for configuration and control.

Connection via a PC COM Port using RS232

Details on establishing serial communication via a PC COM port.

Installing Pathfinder Software

Steps for installing the Pathfinder configuration editor software.

Networking

Connecting Networked Systems

Overview of network hardware components and connection methods.

Commander Programming Kit

Introduction to Programming Kit

Overview of the utility for updating Commander hardware software.

TTProg Software Setup

Instructions for installing the TTProg software utility.

Starting the Programme

Steps to launch the TTProg software and select hardware for reprogramming.

Connecting the Hardware for Programming

Guidance on connecting PC and programming leads to the hardware.

Completing the Reprogram Sequence

Procedures for reprogramming TDM, Talkback controllers, and control panels.

Programming with the 500-16-03 Download Converter

How to use the 500-16-03 converter for programming Commander hardware.

Other Equipment

Telos ONE Alignment Procedure

Steps for aligning the outgoing and incoming levels of the Telos ONE hybrid.

Specification

Matrix Audio Specification

Technical audio specifications for 500-06-02 matrix cards.

Control Panel Configuration

500-3X-5X Series Internal Panel Switch Settings

DIP switch settings for configuring 500-3X-5X series panels.

500-31-60 Programming Cut Switch Operation

How to set cut switch operation via assign mechanism and REN.

Download Converter Supplementary Information

Safety Precautions

General safety precautions for operating the apparatus.