12-6
CLASS C & B
+
MOTORHOME
12.3.3 SHOWER
To protect the surface of your ABS plastic shower
pan, it is recommended that a rubber shower mat be
placed in the shower pan.
Use a non-abrasive cleaner to clean your shower
compartment. Do not use highly concentrated or high
acid content household cleaners, as these may dam-
age the shower compartment.
12.3.2 TOILET
Refer to manufacturer's operating instructions in-
cluded in information package for more details.
Troubleshooting:
1. Water keeps running into the bowl:
Check to see that the levers return all the way to
the left. Sticking may be caused by foreign
material on the waste valve blade or blade seal at
the bottom of the bowl. If problem persists,
replace water valve.
2. Toilet leaks, there is water on the floor:
If the leak is in back of the toilet, check the water
supply line connection and refer to the installation
instructions. If the leak is at the closet flange area,
check the closet flange nuts for tightness. If leak
continues, remove the toilet and check the closet
flange height. The height should be between 1/4"
and 7/16" above the floor. Adjust accordingly and
replace the closet flange seal if damaged.
3. Poor Flush:
The levers must be held fully open during the
flush. A good flush should be obtained within 2 to
3 seconds. If the problem persists, remove the
water supply line and check the water supply.
The water supply line flow rate should be at least
8 liters per minute to ensure an adequate flush.
12.4 PLUMBING SPECIFICATIONS
12.4.1 TANK CAPACITIES
Tank Capacities Gal (L)
Class C
Fresh 36 (136)
Grey 64 (243)
Black 64 (243)
To Next Page
Loading...
