Triple E Regency - 4.6 LIGHT SWITCHES; 4.7 COMFORT CONTROL CENTER

CLASS B
+
& C MOTORHOME
31
4.6 LIGHT SWITCHES
Many rocker or standard light switches are used throughout the motorhome to turn lights on and o. If there is any confu-
sion as to which switch and light work together, try the switch.
4.7 COMFORT CONTROL CENTER (DIGITAL/ANALOG, DIGITAL SHOWN)
A comfort control center is located in the motorhome (living area or bedroom) to control the heating and cooling systems
in the vehicle. The control center is customized to the specications of your vehicle and will control one or more furnaces
and air conditioners.
This liquid crystal display shows the operator the specic operating parameters of the comfort appliances. The display will
change to reect the varying operating selections by the user. For more information see the Operating Instructions in the
Owner's Information Package.
The control functions include:
1. The Power Switch:
Move the power switch right to switch it 'on' and to the left to switch it 'o'.
2 Mode Selector Button:
This push button switch controls the selection of the furnace, air conditioner or the heat strip. Depress the switch
momentarily to select the desired system operating mode. Depress the switch again momentarily to move to the next
selection. The mode selected will show in the Liquid Crystal Display.
3. Fan Speeds:
This push button switch controls the settings for fan speed. Depress the switch momentarily to step the fan through
each setting from low, medium, high and auto. Depress the switch again momentarily to move to the next setting. The
speed selection will show in the Liquid Crystal Display.
4. Temperature Selector Buttons up and Down:
These push buttons raise or lower the selected system temperature. Continue to depress the switch momentarily to
change the temperature to the desired setting. The selected temperature will show in the Liquid Crystal Display.
5. Zone Selector Button:
This push button switch selects the individual zones and stages for the system if your vehicle is equipped with more
than one zone. Depress the switch momentarily to select the desired zone. The selected zone will show in the Liquid
Crystal Display.
WALL
CEILING
THERMOSTAT