Triple E Regency - Water Heater Bypass; Water Pump; Water System Access

CLASS B
+
& C MOTORHOME
34
4.9.2 WATER HEATER BYPASS
The water heater is equipped with a valve that sets its plumbing circuit for normal or winterize. The valve is accessed from
inside the motorhome. The location can vary depending on your specic model.
Watch the pointer on the pivot to determine the valve setting.
1. Normal Operation
2. Bypass Operation
Refer to Section 17 for details on winterizing procedure for cold temperature storage.
4.9.3 WATER PUMP
The water system is equipped with a 12-volt pump that pressurizes the system and moves water to where it is required. The
water pump rocker switch is located on the Monitor panel. Depress the top of the rocker switch to turn the pump on and
the bottom of the switch to turn it o.
It is recommended that the pump switch be turned o whenever leaving the motorhome for any period of time or while
driving. A slow leak in a faucet or connection could drain both the water tank and the battery.
4.9.4 WATER SYSTEM ACCESS
The water system is accessed on the driver's side of the motorhome. Park this side next to the campground utilities for ease
of hook-up.
1. Fresh water tank ll:
a. Connect the water hose to the tank ll tting and open the supply water tap.
b. Turn the tank ll selector valve to ll the fresh water tank. When the tank is full turn it back to normal use.
2. Auxiliary Shower:
a. Hot Water:
This standard water tap controls the ow of hot water to the shower head. Turn clockwise to turn o and counter-
clockwise to turn on.
b. Cold Water:
This standard water tap controls the ow of cold water to the shower head. Turn clockwise to turn o and coun-
terclockwise to turn on.
c. Shower Head:
This standard exible hose shower system is mounted in the compartment. Turn the handle and lift the head to
use it. Turn the collar on the head to restrict the water ow for use as a water saver.
WATER HEATER BYPASS VALVE
1. NORMAL POSITION
2. BYPASS POSITION
a
b