Triumph Speed 400 - Page 91

MAINTENANCE AND ADJUSTMENT
91
CAUTION
The engine oil may be hot.
Avoid contact with the hot engine
oil by wearing suitable protective
clothing, gloves and eye protection.
Contact with the hot engine oil may
cause minor to moderate injury to
exposed skin.
CAUTION
If the engine has recently been
running, the exhaust components may
be hot to the touch.
To avoid skin damage, always allow the
hot parts to cool before touching the
exhaust system.
Contact with the hot components may
cause minor to moderate injury to
exposed skin.
The engine oil and engine oil filter
must be replaced in accordance with
scheduled maintenance requirements.
▼ Remove the two fasteners that
attach the front left cover finisher
and remove the finisher.
clem
1
2
1. Front left cover finisher
2. Fasteners
▼ Remove the fasteners that attach
the front left engine cover and
remove the cover.
clel
1
2
2
2
1. Front left engine cover
2. Fasteners
Engine Oil Strainer
▼ Warm up the engine thoroughly and
stop the engine.
▼ Position the motorcycle on level
ground and in an upright position.
▼ Place an oil drain pan beneath the
engine.
▼ Remove the engine oil drain plug
and discard the O-ring.
▼ Drain the engine oil.
▼ Remove the engine oil strainer.
▼ Clean the engine oil drain plug and
install a new O-ring.