60020-00216 ∙ 00 ∙ 08/2022
Care and maintenanceMover XT4
41EN
1 2
Fig. 33
Switch off the remote control with the slide switch
on the side� (see Kapitel 4.5.1)
After switching on the control unit (e�g� with the bat-
tery cut-off switch), wait (approx� 15seconds) until
the red LED (Fig. 33-2) starts flashing slowly�
Press and hold the reset button (Fig. 33-1) on the
control unit� Wait until the LED (Fig. 33-2) flashes
very quickly�
Press and hold the left ENGAGE button on the
remote control�
Switch on the remote control with the slide switch
on the side while doing so�
Release the left ENGAGE button �
Once the appliances are paired, the red LED (Fig. 33-2)
on the control unit and the symbol on the remote
control light up continously�
If pairing was unsuccessful, the red LED (Fig. 33-2)
flashes and you have to repeat the process�
7 Care and maintenance
RISK
Severe to lethal injury due to short
circuiting
Parts of the appliance are supplied with power
over an on-board power supply consisting of
12V batteries� In the event of high electrical
loads or a short circuit, very high currents can
flow through the supply lines, causing the
cables to heat up and a cable fire to break out�
Fuse cables with appropriate safety fuses�
Cover the battery terminals�
Cover open electrical contacts�
Use isolated plug-in connectors�
NOTICE
Damage to the manoeuvring system due to
incorrect cleaning
Do not clean the manoeuvring system with a
high-pressure cleaner�
Only use gentle detergents�
Cleaning and user-performed maintenance must not be
carried out by children when unsupervised�
7.1 12V battery care
Notes for handling batteries
When handling batteries, pay attention to the
manufacturer’s safety instructions and data sheets�
Ensure that the terminal clamps are secure�
Secure battery poles with protection caps in order to
prevent a short circuit
When removing the battery, first disconnect the
earth connection (negative terminal), followed by the
positive terminal�
When installing the battery, first connect the positive
terminal followed by the negative terminal�
Battery care (including maintenance-free batteries)
In order to achieve a long battery service life, attention
must be paid to the following points:
Batteries should be fully charged before and after
removing power�
For stationary periods of longer than 24hours, inter-
rupt the power circuit (e�g� using the battery cut-off
switch or by disconnecting the battery poles)�
For longer stationary periods the battery must be
disconnected and charged for 24hours at least eve-
ry 12weeks�
In winter, store the fully-charged battery in a cool
and frost-free place and recharge at regular intervals
(every 12 weeks)�
7.2 Remote control care
The remote control must be kept in a dry place�
Remove the remote control’s batteries during exten-
ded stationary periods (e�g� in winter) to prevent the
batteries from going flat�
To Next Page
Loading...
