To Next PageTo Next PageWhy is my Truma Mover XT4 manoeuvring system remote not working properly?
If your Truma Automobile Accessories manoeuvring system isn't responding to the remote or is only working intermittently, it could be due to a low battery in either the remote control or the manoeuvring system itself. Check the battery charge of both. If necessary, charge or replace the battery.
What to do if Truma Automobile Accessories manoeuvring system is not working?
If the Truma Automobile Accessories manoeuvring system isn't working, first check the power supply. Ensure the green LED on the control unit is lit. Also, check the fuse in the battery connection cable and replace it with an original Truma spare part (part no. 60040-00169) if it's defective. If this doesn't resolve the issue, try interrupting the power supply for at least 20 seconds, then restore it and check if the green LED on the control unit is lit.
What to do if Truma Mover XT4 manoeuvring system is not working and red LED is flashing?
If your Truma Automobile Accessories manoeuvring system isn't working and the red LED on the control unit is flashing, the control unit may be overheated. To resolve this, interrupt the power supply using the battery cut-off switch and remove the key. Allow the control unit to cool down for at least 20 minutes before restarting the manoeuvring system.
How to fix Truma Mover XT4 Automobile Accessories drive roller sliding off tyre?
If the drive roller is sliding off the tyre on your Truma Automobile Accessories, check the tyre pressure and adjust it if needed. Inspect the tyre tread and replace the tyres if necessary. Also, disengage the manoeuvring system and measure the gap between the tyres and drive roller, ensuring it is 20 mm.
General| Power supply | 12 V DC |
|---|---|
| Remote control | Yes |
| Automatic engagement | Yes |
| Number of Motors | 2 |
| Suitable for | Caravans and trailers |
| Drive | Electric |
| Installation | Chassis-mounted |
| Type | Electric trailer mover |
