This menu item does not position the RFID tag over the coupler. Make sure to position the tag
over the coupler to receive an accurate writing.
This executable menu writes all twos to the tag in range of the internal RFID coupler. It is
primarily intended for development verification by checking that the system is working.
Note:
This menu item does not position the RFID tag over the coupler. Make sure to position the tag
over the coupler to receive an accurate writing.
It is general read-only and used to gather and report statistics on how the RFID system is reporting on print jobs
sent to the printer.
This menu item displays on the LCD the number of tags attempted to be written since the last
Clear Tag Stat operation has been initiated.
This menu item displays on the LCD the number of failed RFID tags since the last Clear Tag
Stat operation has been initiated.
This menu item displays the number of tags read since the last
Clear Tag Stat operation.
This executable menu item clears the Count menu items in this submenu.
Shows the RFID firmware version installed in the encoder.
Shows the RFID hardware version installed in the encoder.
To Next Page
Loading...
Need help?
General
