◼ The RFID command is sent to the printer,
but RFID is disabled.
◼ Please go to RFID > Control > RFID Active to enable the RFID.
◼ Then process RFID commands.
◼ When the "Non- RFID warning" option is
"ON" (RFID > Control > Non- RFID
Warning), the printer will display this
warning message once the printer has
obtained the non-RFID data.
◼ The tag data sent does not match the
settings.
◼ Please check the tag data of the RFID commands.
◼ The tag length size (the size parameter of
RFID command) sent does not match the
setting.
◼ Please check the data length size of the RFID commands.
To Next Page
Loading...
