TSC DA220 Series User Manual

- 10 -
3. Setup
3.1 Setting up the Printer
1. Place the printer on a flat, secure
surface.
2. Make sure the power switch is off.
3. Connect the printer to the computer
with the provided USB cable.
4. Plug the power cord into the AC
power cord socket at the rear of the
printer, and then plug the power cord
into a properly grounded power
outlet.
Note:
* Please switch OFF (O) printer power switch prior to plug in the power cord to printer power
jack.
* The interface picture here is for reference only. Please refer to the product specification for
the interfaces availability.

TSC DA220 Series Specifications

General

Resolution	203 dpi / 300 dpi
Print Speed	Up to 152.4 mm (6”) per second
Print Width	54 mm (2.12”)
Memory	8 MB SDRAM
Processor	32-bit RISC
Interface	USB
Operating Temperature	-40°C to 60°C
Storage Temperature	-40 ~ 60°C (-40 ~ 140°F)
Power Supply	100-240V AC, 50/60 Hz