TSC MB240 Series Service Manual

11
3.3 Replacing the Platen Roller Assembly
1. Refer to Remove the Lower Front Panel to remove the lower front panel.
2. Release the platen roller bush tabs then push it to the end of mechanism on both sides as indicated.
3. Pull up and remove platen roller assembly.
4. Remove/Replace the platen roller assembly.
5. Reassemble the parts in the reverse procedures.
Platen roller assembly
Platen roller bush tabs

TSC MB240 Series Specifications

General

Print Method	Thermal Transfer/Direct Thermal
Resolution	203 dpi
Processor	32-bit RISC CPU
Operating Humidity	25-85% non-condensing
Connectivity	USB 2.0, RS-232
Media Sensor	Reflective, Transmissive
Media Type	Continuous, Die-cut, Black mark, Fan-fold, Notched
Media Width	25.4 mm
Media Thickness	0.06 mm
Media Core Diameter	25.4 mm (1")
Media Max Roll Diameter	127 mm (5")
Ribbon Width	110 mm
Ribbon Length	300 m
Ribbon Core Diameter	25.4 mm (1 inch)
Power	100 - 240 VAC, 50/60 Hz
Maximum Print Length	9999 mm
Label Width	25.4 mm
Label Thickness	0.06 mm
Power Supply	100-240V AC, 50-60Hz
Operating Temperature	5°C - 40°C
Storage Temperature	-20°C - 60°C
Certifications	CE